[Elecraft] Power Calibration - Transverter

[Jim - W6VAR]

When doing the power calibration for the transverter, there is no mention in
the manual of attaching any form of (dummy) load. Is this not necessary due
to the low power level? Wouldn't a specific impedance be necessary to
accuratly calibrate?

I'm not using a trasverter right now, but have run the calibration and would
like to know the correct way of presenting a load if needed.

Thanks,

Jim - W6VAR
-- 
View this message in context: http://n2.nabble.com/Power-Calibration---Transverter-tp1930595p1930595.html
Sent from the Elecraft mailing list archive at Nabble.com.