[Elecraft] Re: Transmit when switching from DATA to AM mode?

[Greg]

How high is your VOX setting?

----- Original Message ----- 
From: "Bill Coleman N2BC" <n2bc at stny.rr.com>
To: "K2MK" <k2mk at comcast.net>; <jplan at jeffnet.org>; "Elecraft Reflector" 
<elecraft at mailman.qth.net>
Sent: Friday, December 26, 2008 7:08 AM
Subject: Re: [Elecraft] Re: Transmit when switching from DATA to AM mode?


> S/N 00929 /w FW 2.76, 6.0 kHz filter.  Confirmed TX on switch from DATA to
> AM when VOX on.  Getting typical AM carrier output for about 1 second.
> Happens from either front panel mode change or PC control (two different
> programs).
>
> Happens from DATA to AM and DATAR to AM (I tried all combinations xx to AM
> via PC control).
>
> Also occurs /w 6.0 kHz filter disabled, and on any band.
>
> I THINK I spotted ERR ??? once on VFO B display but vy intermittent - 
> could
> (should) not have been END as I was mid-point on all the bands.
>
> This has been around a long time... I went back to FW 1.96 (oldest I have) 
> &
> it happens there!
>
> 73, Bill   N2BC
> ----- Original Message ----- 
> From: "K2MK" <k2mk at comcast.net>
> To: <jplan at jeffnet.org>; "Elecraft Reflector" <elecraft at mailman.qth.net>
> Sent: Friday, December 26, 2008 8:25 AM
> Subject: [Elecraft] Re: Transmit when switching from DATA to AM mode?
>
>
>> Hi Joe:
>>
>> Consider the possibility of it being the software program you are running
>> on your PC in DATA mode. Quit the program first then switch to AM.
>>
>> It's frequently a safe bet to blame the computer for anything that goes
>> wrong.
>>
>> 73,
>> Mike K2MK
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.10.0/1864 - Release Date: 12/25/2008 
9:40 AM