[Elecraft] Re: Transmit when switching from DATA to AM mode?

[Bill Coleman N2BC]

S/N 00929 /w FW 2.76, 6.0 kHz filter.  Confirmed TX on switch from DATA to 
AM when VOX on.  Getting typical AM carrier output for about 1 second. 
Happens from either front panel mode change or PC control (two different 
programs).

Happens from DATA to AM and DATAR to AM (I tried all combinations xx to AM 
via PC control).

Also occurs /w 6.0 kHz filter disabled, and on any band.

I THINK I spotted ERR ??? once on VFO B display but vy intermittent - could 
(should) not have been END as I was mid-point on all the bands.

This has been around a long time... I went back to FW 1.96 (oldest I have) & 
it happens there!

73, Bill   N2BC
----- Original Message ----- 
From: "K2MK" <k2mk at comcast.net>
To: <jplan at jeffnet.org>; "Elecraft Reflector" <elecraft at mailman.qth.net>
Sent: Friday, December 26, 2008 8:25 AM
Subject: [Elecraft] Re: Transmit when switching from DATA to AM mode?


> Hi Joe:
>
> Consider the possibility of it being the software program you are running 
> on your PC in DATA mode. Quit the program first then switch to AM.
>
> It's frequently a safe bet to blame the computer for anything that goes 
> wrong.
>
> 73,
> Mike K2MK
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>