[Elecraft] K3 Subreceiver ANT selection doesn't work - always uses the AUX antenna

[Gregory Fischer]

I hear a click when KRX3 in CONFIG is set to either ATU or BNC.

BTW, you do not need to use BSET and then ANT to change between Main  
and AUX for the sub receiver.  You can do it with a HOLD of the RX ANT  
button too.

73 and Merry Christmas
Greg
AB7R


On Dec 24, 2008, at 2:53 PM, Frank R. Oppedijk wrote:

> Barry,
>
> Thanks for your information.
>
> Is the mechanical click when switching between MAIN and AUX also if  
> you have the CONFIG KRX3 set to ANT=BNC, or only when using ANT=ATU ?
>
> According to Willis 'Cookie' Cooke, K5EWJ, the switching is in the  
> KAT3 only, and the KAT3 is of course out of the circuit when using  
> the BNC connector as the subreceiver's aux antenna input...
>
> Thanks,
>
> Frank PA4N
>
>
> At 19:22 24/12/2008, Barry N1EU wrote:
>
>
>
>> Frank R. Oppedijk wrote:
>> >
>> > Should there be an audible relay click when toggling BSET ANT I
>> > between "MAIN" and "AUX"? When I do that, there is no relay click
>> > whatsoever...
>> >
>> Yes, there is definitely an audible mechanical click of a relay  
>> when you
>> toggle between AUX and MAIN antenna for the subreceiver.
>>
>> 73,
>> Barry N1EU
>>
>> --
>> View this message in context: http://n2.nabble.com/K3-QRP-output-power-level-tp1745497p1778652.html
>> Sent from the Elecraft mailing list archive at Nabble.com.
>>
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft
>>
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>
>
> ---
> drs. ing. F.R. Oppedijk
> Avista ICT Consultancy B.V.
> Albert Schweitzerlaan 7
> 1277 BV  Huizen
>
> tel: 035 - 523 09 83
> fax: 035 - 523 09 84
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com