[Elecraft] K3 Subreceiver ANT selection doesn't work - always uses the AUX antenna

[Frank R. Oppedijk]

Barry,

Thanks for your information.

Is the mechanical click when switching between MAIN and AUX also if 
you have the CONFIG KRX3 set to ANT=BNC, or only when using ANT=ATU ?

According to Willis 'Cookie' Cooke, K5EWJ, the switching is in the 
KAT3 only, and the KAT3 is of course out of the circuit when using 
the BNC connector as the subreceiver's aux antenna input...

Thanks,

Frank PA4N


At 19:22 24/12/2008, Barry N1EU wrote:



>Frank R. Oppedijk wrote:
> >
> > Should there be an audible relay click when toggling BSET ANT I
> > between "MAIN" and "AUX"? When I do that, there is no relay click
> > whatsoever...
> >
>Yes, there is definitely an audible mechanical click of a relay when you
>toggle between AUX and MAIN antenna for the subreceiver.
>
>73,
>Barry N1EU
>
>--
>View this message in context: 
>http://n2.nabble.com/K3-QRP-output-power-level-tp1745497p1778652.html
>Sent from the Elecraft mailing list archive at Nabble.com.
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com


---
drs. ing. F.R. Oppedijk
Avista ICT Consultancy B.V.
Albert Schweitzerlaan 7
1277 BV  Huizen

tel: 035 - 523 09 83
fax: 035 - 523 09 84