[Elecraft] Update and another request Lost SSB after KRX3 install..Ideas?

[Dick Dievendorff]

Have you enabled the 2.7 kHz filter for all modes in receive using the
CONFIG FLx menu or the K3 Utility's Crystal Filter Configuration page?

 

Dick, K6KR

 

 

From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Howard K2HK
Sent: Sunday, December 07, 2008 7:33 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Update and another request Lost SSB after KRX3
install..Ideas?

 

After sending the msg below I removed the KRX3 and also reinstalled the 2.7
filter whose position had been moved on the RF board. Neither of these made
any difference. KRX3 works as expected, CW works as usual but......no audio
output on SSB. 
Howard..K2HK



HK


No TX audioDate: Sat, 6 Dec 2008 
18:12:28 +0000

I recently installed the KRX3 in my K3. At the same time I moved some
filters 
and installed an additional one on the main board . I now have the problem
of 
no audio on SSB. Works FB on CW. I am thinking the culprit is likely to be
the 
2.7KC filter on the main board. Before opening up things again I thought I 
would ask for some suggestions.Howard..K2HK 
HK

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081207/c5899174/attachment.htm