[Elecraft] K3 Beta Firmware, Revision 2.31 E 00000C ERR DSE

[Christopher Kovacs]

Looks like it was my mistake....  I could have swore that the DSP was 
being loaded the first time.  I went back to the previous firmware and 
then reloaded the latest beta firmware making sure that I send "all".

It's good now.

Chris  w0anm

David Wilburn wrote:
> Same firmware here.
>
> Set pitch to 630
>
> Width to .80
>
> Varied shift from lowest setting to highest without issues.
>
> There were two loads that needed to be added for this firmware.  Did 
> you add the DSP as well as the MCU?
>
> David Wilburn
> K4DGW
> www.k4dgw.com
> www.k4rc.net
> Williamsburg Area Amateur Radio Club (K4RC)
>
> My Current LOTW/DXCC/WAS status
> www.k4dgw.com/WAS.DXCC.info.html
>
>
>
> Christopher Kovacs wrote:
>> Hi all,
>>
>> I just upgraded to the latest beta.  Set pitch to 630 and then varied 
>> the "WIDTH" and SHIFT".  Set the WIDTH for 0.80 then when  shifting 
>> passed FC 0.35, the receiver dies with an error "E 00000C" ERR DSE.
>>
>> It doesn't appear to matter what the "pitch" tone is set.  After the 
>> error occurs, you must change the SHIFT setting > 0.35 and power off 
>> and on.
>>
>>
>> Chris  W0ANM
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft   Help: 
>> http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>