[Elecraft] K3 Beta Firmware, Revision 2.31 E 00000C ERR DSE

[David Wilburn]

Same firmware here.

Set pitch to 630

Width to .80

Varied shift from lowest setting to highest without issues.

There were two loads that needed to be added for this firmware.  Did 
you add the DSP as well as the MCU?

David Wilburn
K4DGW
www.k4dgw.com
www.k4rc.net
Williamsburg Area Amateur Radio Club (K4RC)

My Current LOTW/DXCC/WAS status
www.k4dgw.com/WAS.DXCC.info.html



Christopher Kovacs wrote:
> Hi all,
> 
> I just upgraded to the latest beta.  Set pitch to 630 and then varied 
> the "WIDTH" and SHIFT".  Set the WIDTH for 0.80 then when  shifting 
> passed FC 0.35, the receiver dies with an error "E 00000C" ERR DSE.
> 
> It doesn't appear to matter what the "pitch" tone is set.  After the 
> error occurs, you must change the SHIFT setting > 0.35 and power off and 
> on.
> 
> 
> Chris  W0ANM
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>