[Elecraft] K3 Beta Firmware, Revision 2.31 E 00000C ERR DSE

[David Wilburn]

Awesome, glad to hear it is up and running.

David Wilburn
K4DGW
www.k4dgw.com




Christopher Kovacs wrote:
> Looks like it was my mistake....  I could have swore that the DSP was 
> being loaded the first time.  I went back to the previous firmware and 
> then reloaded the latest beta firmware making sure that I send "all".
> 
> It's good now.
> 
> Chris  w0anm
> 
> David Wilburn wrote:
>> Same firmware here.
>>
>> Set pitch to 630
>>
>> Width to .80
>>
>> Varied shift from lowest setting to highest without issues.
>>
>> There were two loads that needed to be added for this firmware.  Did 
>> you add the DSP as well as the MCU?
>>
>> David Wilburn
>> K4DGW
>> www.k4dgw.com
>> www.k4rc.net
>> Williamsburg Area Amateur Radio Club (K4RC)
>>
>> My Current LOTW/DXCC/WAS status
>> www.k4dgw.com/WAS.DXCC.info.html
>>
>>
>>
>> Christopher Kovacs wrote:
>>> Hi all,
>>>
>>> I just upgraded to the latest beta.  Set pitch to 630 and then varied 
>>> the "WIDTH" and SHIFT".  Set the WIDTH for 0.80 then when  shifting 
>>> passed FC 0.35, the receiver dies with an error "E 00000C" ERR DSE.
>>>
>>> It doesn't appear to matter what the "pitch" tone is set.  After the 
>>> error occurs, you must change the SHIFT setting > 0.35 and power off 
>>> and on.
>>>
>>>
>>> Chris  W0ANM
>>> _______________________________________________
>>> Elecraft mailing list
>>> Post to: Elecraft at mailman.qth.net
>>> You must be a subscriber to post to the list.
>>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>> http://mailman.qth.net/mailman/listinfo/elecraft   Help: 
>>> http://mailman.qth.net/subscribers.htm
>>> Elecraft web page: http://www.elecraft.com
>>>
>>
> 
>