[Elecraft] Hi Cur error on alignment part III, even at QRPp. 40m only. Rx is good.

[Hagood, Larry]

Hi folks. I'm finishing a new K2 for a friend. When I tried to perform the 40m Tx alignment, I instantly get "HI Cur" and the power drops to zero. This happens if the output power is set to anything above 0.3 watts. This only happens on 40 meters. I was able to peak the output on all the other bands normally.  The Cal Cur is set to 2.5. 
I've got the little RF probe built. could someone point me in the right direction as to where to look for the problem?  
Thank you verrrrrry much!
 
73,
AD5VM
 
Larry Hagood
KLA-Tencor 
Customer Service Engineer 
Intel Service Business Unit 
Mobile: 505-563-0338 
KLA-TENCOR CONFIDENTIAL
This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error, do not use or review the message or any information transmitted with it, and notify the sender.