[Elecraft] Hi Cur error on alignment part III, even at QRPp. 40m only. Rx is good.

[Don Wilhelm]

Larry,

If it only happens on 40 meters you have some problem with the 40 meter 
Low Pass Filter.
Look at the schematic for RF Board sheet 3 toward the lower right and 
you will see the components associated with the 40/60 meter LPF - check 
them all for proper values, correct turns on toroids, good soldering, 
etc.  Include relay K12 as well.

73,
Don W3FPR

Hagood, Larry wrote:
> Hi folks. I'm finishing a new K2 for a friend. When I tried to perform the 40m Tx alignment, I instantly get "HI Cur" and the power drops to zero. This happens if the output power is set to anything above 0.3 watts. This only happens on 40 meters. I was able to peak the output on all the other bands normally.  The Cal Cur is set to 2.5. 
> I've got the little RF probe built. could someone point me in the right direction as to where to look for the problem?  
> Thank you verrrrrry much!
>  
> 73,
> AD5VM
>
>