[Elecraft] HI CUR question

[Stephen W. Kercel]

Larry:

Any chance your supply voltage is running low?

73,

Steve Kercel
AA4AK


At 08:01 PM 10/8/2007, Larry  Naumann wrote:
>I sometimes get a HI CUR warning on my new K2. I have the high 
>current set at 2.5 amps. My power supply is steady but on 40 meters 
>when the SWR is slightly high but below 2:1, I get a HI CUR when 
>running 10 watts out. Into a good 50 ohm dummy load I get 2.02 amps 
>on 40 meters.
>  I've double checked my output filter tuning and all is good.
>Is this something to be concerned about or is this in the normal 
>range of xmit current at 10 watts?
>Larry Naumann  N0SA
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com