[Elecraft] K3 Mic Menu,TX Equalizer & Low Power Software Request

[Don Nesbitt]

Julian - I had not gotten that far with my K3 but just checked it - and -
couldn't agree more!  Auto on Ant1 is Auto on Ant2, Bypass on Ant1 is Bypass
on Ant2 - these need to be independent.

That, along with a simple way to completely clear a CW memory ought to be
fairly easy to implement.
  
Over the years, I've really tried to keep my posts to the reflector and to
Eric at an absolute minimum - so - you won't see much from me in the
"public" arena.

73 -- Don N4HH K3 #83

<SNIP> Julian wrote:

I can tune my MFJ magnetic loop using 1W and reading the SWR off the
KAT2 in CAL S mode. But it's really annoying to do this and hear the
KAT2 start clicking away because I'd switched to the other antenna and
put the KAT2 on AUTO again and forgotten to switch it off when going
back to the loop.

If the KAT3 could be configured separately for the two antenna
sockets, that would be a big plus for me.
-- 
Julian, G4ILO K2 s/n: 392  K3 s/n: ???