[Elecraft] K3 Mic Menu,TX Equalizer & Low Power Software Request

[Julian G4ILO]

On Nov 28, 2007 3:17 PM, David Ferrington, M0XDF <M0XDF at alphadene.co.uk> wrote:
> I second all of these. I will be using 2 mcs too and I have an SGC I wish to
> tune, I'd like to be able to set the 'low rf output for tune' level as well,
> the SG-237 will tune on 3W.

I can tune my MFJ magnetic loop using 1W and reading the SWR off the
KAT2 in CAL S mode. But it's really annoying to do this and hear the
KAT2 start clicking away because I'd switched to the other antenna and
put the KAT2 on AUTO again and forgotten to switch it off when going
back to the loop.

If the KAT3 could be configured separately for the two antenna
sockets, that would be a big plus for me.
-- 
Julian, G4ILO K2 s/n: 392  K3 s/n: ???
G4ILO's Shack: www.g4ilo.com
Zerobeat Ham Forums: www.zerobeat.net/smf