[Elecraft] K2-S-Meter Alignment question

[Gary Marks]

I should have done as in the first step....after entering the menu again and 
selecting CAL S HI, I should have done:
Hold "EDIT" a second time to activate it. That sentence wasn't in the manual 
and I'm just learning the procedures with this rig. Everything checked out 
OK. On to Assembly, Part II.
THANKS

Gary

>
> You missed one prior step - enter the menu and edit 'CAL S Hi' first, and
> then the VFO knob should work as described - you should see a display like
> 'S HI 018' (the number will change as you rotate the VFO knob).
>
> 73,
> Don W3FPR
>
>
>> -----Original Message-----
>> Under S-Meter Alignment:
>>
>> The forth step says:
>> Turn RF Gain fully counter-clockwise. Adjust the VFO knob until
>> bargraph segment 9 lights, then turn it a bit more
>> counter-clockwise until segment 10 just turns on (right-most segment).
>>
>> Question: Should this have said RF Gain instead of VFO knob ?
>> Turning the VFO does nothing while turning the RF Gain knob
>> performs what the instructions say.
>>
>>
>