[Elecraft] K2-S-Meter Alignment question

[Nick Waterman]

Gary Marks wrote:
> The forth step says: Turn RF Gain fully counter-clockwise. Adjust the
> VFO knob until bargraph segment 9 lights, then turn it a bit more
> counter-clockwise until segment 10 just turns on (right-most
> segment).
> 
> Question: Should this have said RF Gain instead of VFO knob ?
> Turning the VFO does nothing while turning the RF Gain knob performs
> what the instructions say.

Even if you're in "CAL S HI"?

You might need to turn AGC off (hold PRE/ATT and AGC) before you start
CAL S HI and CAL S LO.

-- 
"Nosey" Nick Waterman, G7RZQ, K2 #5209.
use Std::Disclaimer;    sig at noseynick.net
Please sponsor me! http://www.justgiving.com/noseynick
Anything worth doing is worth doing badly. -- G. K. Chesterton