[Elecraft] N-GEN noise generator question

[Robert Friess]

Hi Bob,

It makes no difference.  The device is symmetrical when rotated.  The two 
leads that become reversed are both ground.

73,
Bob, N6CM


----- Original Message ----- 
From: <BobConvers at aol.com>
To: <elecraft at mailman.qth.net>
Sent: Friday, November 26, 2004 8:22 AM
Subject: [Elecraft] N-GEN noise generator question


This is my first kit in over 35 years, so I have a basic question. The N-GEN
noise generator kit uses a surface mount device designated MAR-1 as U1, a
tiny drum-shaped body with four leads protruding radially outward from the
center. The end of one of the leads is cut at a slant.   The kit 
instructions say
to orient the slant-cut lead toward the center of the circuit board. 
However,
I'm not sure which side of the device should be facing up.

One side of the device is labeled ".10", with an underscore under the zero,
and I would assume this side should be facing up. However, the directions 
also
say that the body of the device will fit into the hole in the board between
the pads, so if I place the longer side of the body of the device into the 
hole
(to have more of the device extending into the hole), the label is now face
down. Both orientations result in the four leads positioned above the pads 
on
the board and both have the slant-cut lead pointing to the center of the
board - which should I use?

73,
Bob, WO3E

PS: It's great to bebuilding again, but DANG - these modern   parts are
small!
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): 
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com