[Elecraft] N-GEN noise generator question

[BobConvers at aol.com]

This is my first kit in over 35 years, so I have a basic question.  The N-GEN 
noise generator kit uses a surface mount device designated MAR-1 as U1, a 
tiny drum-shaped body with four leads protruding radially outward from the 
center.  The end of one of the leads is cut at a slant.   The kit instructions say 
to orient the slant-cut lead toward the center of the circuit board.  However, 
I'm not sure which side of the device should be facing up.  

One side of the device is labeled ".10", with an underscore under the zero, 
and I would assume this side should be facing up.  However, the directions also 
say that the body of the device will fit into the hole in the board between 
the pads, so if I place the longer side of the body of the device into the hole 
 (to have more of the device extending into the hole), the label is now face 
down.  Both orientations result in the four leads positioned above the pads on 
the board and both have the slant-cut lead pointing to the center of the 
board - which should I use?

73,
Bob, WO3E

PS: It's great to bebuilding again, but DANG - these modern   parts are 
small!