[Elecraft] TP3 es PWR output on 20mx

[David Walker]

Please ignore this.... I also re-adjusted my CAL/CUR to 3.00.  I put it back
up to 3.50 and now I get my 14 watts out.

Lesson in this is.... check everything out thoroughly before you make a fool
of yourself in front of a cast of thousands.

:-)

Dave.


----- Original Message ----- 
From: "David Walker" <vk2icq at dodo.com.au>
To: <Elecraft at mailman.qth.net>
Sent: Monday, May 17, 2004 7:50 PM
Subject: [Elecraft] TP3 es PWR output on 20mx


I normally get around 13 watts out on 20mx.  However I connected the probe
to TP3 to check my BFO frequencies yesterday and I noticed that my maximum
output power is now just under 10 watts.

I should open the rig up again and remove it to get a better correlation but
my wife beckons my attention!  Has anyone else noticed this?

(My power output on 10mx still around 6.5 watts, I've tried rewinding all
the bits and pieces but can't increase it.  A real bugbear with this radio
because I've been told that 14 watts is normal for 10 mx.)

Dave
SN 3222
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/elecraft
You must be a subscriber to post.
Elecraft web page: http://www.elecraft.com