[Elecraft] K1 Alignment and test problem

Sat Mar 13 20:43:00 2004

If you are indeed getting your 8 and 6 volts where you are supposed to
be getting them, then I would first go back and double check all the
solder connections on the front panel.  Then go to problem 26 for
possible MCU problems.

But I'd be willing to wager there's a bad solder connection somewhere or
maybe a component was installed backwards.

In any event, good luck!

73 de Larry W2LJ - Vivat Morse! � �

[email protected]
http://www.qsl.net/w2lj

ARRL Lifemember  QRP ARCI #4488     NJQRP #47
FISTS #1469  QRP-L #778   FP #612  QRPp-I #759
ARS #1528,  AmQRP, CQC #746

K1 #1647  -  K2 #4090  for QRP
Icom IC-751A for QRO
Butternut HF9V and G5RV antennas
----- Original Message -----
From: <[email protected]>
To: <[email protected]>
Sent: Saturday, March 13, 2004 8:21 PM
Subject: [Elecraft] K1 Alignment and test problem

> When I turned on the K1 for the alignment and test (p.36 of the
manual),
> I got nothing - no LED lit up, and nothing on the LCD.  All components
> were cool, as was the cord from the power supply to the K1.  I looked
at
> troubleshooting, problem 00, and everything there appears to check
out.
>
> Where to look next?
>
> ________________________________________________________________
> The best thing to hit the Internet in years - Juno SpeedBand!
> Surf the Web up to FIVE TIMES FASTER!
> Only $14.95/ month - visit www.juno.com to sign up today!
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see:
http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
>