[Elecraft] K2: RFC11

[Don Brown]

Hi

I use a small square of double stick foam tape for RFC11 and T2 in the transmitter. This tape is about 1/16 inch thick so it works on T2 to mount it up above the board a little to improve the output on 10 meters.

Don Brown


  ----- Original Message ----- 
  From: Linden, Mike (BRC-Hes)<mailto:Mike.Linden at boschrexroth-us.com> 
  To: 'elecraft at mailman.qth.net'<mailto:'elecraft at mailman.qth.net'> 
  Sent: Monday, June 14, 2004 8:49 AM
  Subject: [Elecraft] K2: RFC11


    I'm looking for input on the winding and installation of toroid RFC11
  which mounts underneath the K2's RF board. Assuming I wind RFC11 such that
  85% of the toroid is used, I don't see how it can "easily" be secured by the
  leads given the location of the lead holes. How has this worked out for
  folks who have built their K2s?

    Thanks, Michael  N9BDF
    K2 SN #4137


  PS  The "Amateur Radio Emergency Communications Consistency Act" (HR 1478)
  and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are in
  Congress. Please contact your Congressmen to ask for their support of these
  bills! See the following ARRL link for details:
  http://www.arrl.org/govrelations/<http://www.arrl.org/govrelations/> <http://www.arrl.org/govrelations/<http://www.arrl.org/govrelations/>> 


  _______________________________________________
  Elecraft mailing list
  Post to: Elecraft at mailman.qth.net<mailto:Elecraft at mailman.qth.net>
  http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft>
  You must subscribe to post.
  Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm>
  Elecraft page: http://www.elecraft.com<http://www.elecraft.com/>