[Elecraft] K2: RFC11

[Lawrence Makoski]

Michael,

I wound RFC11 exactly as directed by the instruction manual; and I had
no problem.  I even went downstairs and took the bottom cover off my K2
just to doublecheck.  I am in the phase of aligning the filters befoere
starting Assebly Part III of the RF board.  If you're using the proper
holes it shouldn't be a problem.

73 de Larry W2LJ - Vivat Morse! © ®

W2LJ at arrl.net
http://www.qsl.net/w2lj

ARRL Lifemember  QRP ARCI #4488     NJQRP #47
FISTS #1469  QRP-L #778   FP #612  QRPp-I #759
ARS #1528,  AmQRP, CQC #746

K1 #1647  -  K2 #4090  for QRP
Icom IC-751A for QRO
Butternut HF9V and G5RV antennas
----- Original Message -----
From: "Linden, Mike (BRC-Hes)" <Mike.Linden at boschrexroth-us.com>
To: <elecraft at mailman.qth.net>
Sent: Monday, June 14, 2004 9:49 AM
Subject: [Elecraft] K2: RFC11


>   I'm looking for input on the winding and installation of toroid
RFC11
> which mounts underneath the K2's RF board. Assuming I wind RFC11 such
that
> 85% of the toroid is used, I don't see how it can "easily" be secured
by the
> leads given the location of the lead holes. How has this worked out
for
> folks who have built their K2s?
>
>   Thanks, Michael  N9BDF
>   K2 SN #4137
>
>
> PS  The "Amateur Radio Emergency Communications Consistency Act" (HR
1478)
> and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are
in
> Congress. Please contact your Congressmen to ask for their support of
these
> bills! See the following ARRL link for details:
> http://www.arrl.org/govrelations/ <http://www.arrl.org/govrelations/>
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/elecraft
> You must subscribe to post.
> Subscriber Info (Addr. Change, Unsub etc):
http://mailman.qth.net/subscribers.htm
> Elecraft page: http://www.elecraft.com
>