[Elecraft] K2: RFC11

[Linden, Mike (BRC-Hes)]

  I'm looking for input on the winding and installation of toroid RFC11
which mounts underneath the K2's RF board. Assuming I wind RFC11 such that
85% of the toroid is used, I don't see how it can "easily" be secured by the
leads given the location of the lead holes. How has this worked out for
folks who have built their K2s?

  Thanks, Michael  N9BDF
  K2 SN #4137


PS  The "Amateur Radio Emergency Communications Consistency Act" (HR 1478)
and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are in
Congress. Please contact your Congressmen to ask for their support of these
bills! See the following ARRL link for details:
http://www.arrl.org/govrelations/ <http://www.arrl.org/govrelations/>