[Elecraft] KAT2 - Assy Manual Clarification; Typo's?

[Paul Clay]

Would appreciate clarification of several items:

1.  Regarding placement of lock washers, on page 
12 of the manual it indates that on the ATU 
control board, the spacers are supposed to be 
between the PC board and screws; this is contrary 
to what's indicated on page 6 of the manual and 
contrary to what 26 Feb 2000 KAT2 Builder Alert.

Am I  correct that the intention here is to place 
spacers between the standoffs and the PC board 
with respect to BOTH the ATU control board and 
the L-C board?  (So its screw - atu board - 
spacer - standoff - spacer - LC board - screw?)

2.  I assume the reference in the first step on 
manual page 12 to RF-P3 as mating to the ATU 
connector J7 is a typo; the correct reference is 
supposed to be to RF-P6?

3. On page 11, the third to last step is supposed 
to be solder the braid and center conductor at 
one end of the coax cable to the pads labeled 
"GND and RF" (vice "RF and GND"), right?

Thanks,
Paul N6LQ