[Elecraft] Alignment + Test, Part 1, current draw

Thu Jan 1 21:16:18 2004

Hi Markus!
Your OK.
Nothing to worry about.
I just completed K2 3829 and had same readings as you.
My display was 0,10-0,12 amps at same stage.
If you set display into daymode your current will go down.
Enjoy.
Tom LA1PHA

----- Original Message -----=20
From: <[email protected]>
To: <[email protected]>
Sent: Thursday, January 01, 2004 11:40 PM
Subject: [Elecraft] Alignment + Test, Part 1, current draw

> Hi all,
> I just finished the alignment and test in part 1. Everything was ok,
> except of the current reading: It should be 60 to 80 mA, my reading
> was 100 mA (LCD: nite, no bars on). As I knew from this wonderful
> reflector, the K2 current display isn't always accurate, so I measured
> the current with a DMM in series in the power supply. The reading
> was 110 mA, which  is even worse. Should I be concerned ?
>=20
> tnx, 73 de Markus, HB9TJW
>=20
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be subscribed to post to the list.
> To subscribe or unsubscribe see: =
http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
> Also see: http://www.elecraft.com/elecraft_list_guidelines.htm
> 