[Elecraft] MH-2 Resistor

[Darrell Bellerive]

My MH-2 microphone arrived without the 5.6k resistor. No problem, I
thought, I have a great selection of resistors. However no 5.6k. If
anyone at Elecraft is reading, don't bother sending a replacement. I
will figure something out.

I also will probably want to mount the resistor in the microphone
connector rather than the back of the jack on the front panel board.

So, two questions:
1) What is the range of resistance that is acceptable for the
microphone? I could build a close value out of a couple of resistors.

2) Is it possible to locate the resistor in the microphone case itself
rather than the connector? I have seen the caution about opening the
microphone and didn't want to open it to take a peak for fear I would
not get it back together.

73,   Darrell   VE7CLA   K2 #1973