[Elecraft] KAT2 and K60XV interaction

[Philip L Carter]

I too am using the kat2 and the kx60v with a split kat100/kpa100.  When I
measured the output at the xvtr ouyt jacks with the com120c analyzer, I
noticed no problems.  With the output programmed to 1mw, I recorded 1mw on
the analyzer.  All firmware was updated at the same time in all modules.

Did I miss something here?  I thought if the output was coming from the
xvtr out jacks, the kat2 was ouit of the picture.  I didn't test it at the
antenna output jacks at that point.  I thought the swr bridge was after
the kat2.

Phil #370


NRE/COLE Test Center OH-3
pcarter@gcfn.org or wd8qwr@arrl.net
Philip L. Carter, WD8QWR
wd8qwr@w8cqk.#cmh.oh.usa.na