[Elecraft] Another K@ frequency calibration technique

[Ron D'Eau Claire]

Right you are Mike...

That's always the issue when the rigs get more complex. With every added
oscillator is a whole spectrum of harmonics, heterodynes, heterodynes of
harmonics, etc..

Ron AC7AC
K2 # 1289

-----Original Message-----
<snipo>
(If you have the KPA100 operating, it's 4 MHz clock may be interfering =
with
you. If so adjust it to a higher frequency. Elecraft recommends this to =
keep
it from interfering with signals at the top of the 75 meter band. The
frequency of the 4 MHz clock in the KPA100 is not critical and has no =
effect
on any calibration). <snipo>

And instead you can interfere with low level signals at the bottom of =
the 10
metre band.

Take your pick.

Regards,

Mike VP8NO