[Elecraft] SN 3222 - K2 Built and running

[Don Wilhelm]

Dave,
You need to do an alignment of the BFO's to match your filters.
I would recommend that you use Spectrogram and a wideband noise generator to
do this alignment - you can see the filter bandpass and set the BFO so that
it is centered at your chosen sidetone frequency.

You can obtain additional information on using Spectrogram to do this job on
the Builder's Resource page at www.elecraft.com.

I don't have a response about the 'squeel' - perhaps someone else can
provide an answer.

73,
Don W3FPR

----- Original Message -----
On LSB when I switch from FL1 to FL2 the reciever shifts down about 600hz
(so I have to tune up to find the signal. On CW the rx shifts up only a few
hz when the FL2 filter is on.)

Switching between CW and CW-R I have to tune up about 1Khz to find the
signal.