[Elecraft] K2 akignment and test, part II - solved!

Sat Jun 14 21:55:00 2003

As far as tinning toroid leads goes; Scott at Emtech has a great video on
his Website that you can watch using Realplayer or Windows Media Player.  He
shows how he does it and his method worked great for me when I built my ZM2
ATU.

Here's the url:
http://emtech.steadynet.com/gallery.shtml

Standard disclaimer - I'm not an owner, partner to or relative of Scott at
Emtech.  Just a satisfied customer who found this little added bit of
customer service to be a nice touch.

73 de Larry W2LJ

[email protected]
http://www.qsl.net/w2lj

QRP ARCI #4488     NJQRP #47
FISTS #1469  QRP-L #778   FP #612

----- Original Message -----
From: "Bob Nielsen" <[email protected]>
To: <[email protected]>
Sent: Saturday, June 14, 2003 9:35 PM
Subject: Re: [Elecraft] K2 akignment and test, part II - solved!

> Tom,
>
> There is such a notation.
>
> On page 51 of the Rev E K2 manual, after installing the first toroid
> (RFC14) it says, "Measure from pad to pad (not wire to wire) using an
> ohmmeter to be sure the leads are making contact."  This is good advice
> for ALL toroid connections.
>
> Stripping and soldering the magnet wire used on the various toroids is
> probably the trickiest part of the whole assembly process.