[Elecraft] K2 akignment and test, part II

[Thomas M. Beaudry]

I just found my problem so you may want to check if you did the same...

I reversed the pins when I put them in the connector!!!!  Shows exactly
what it's supposed to show now.

73,

> I'm working on the RF board for my K2 #3452 and ran into a problem on the
> alignment and test part II.
> 
> Just started the test and ran into a problem on the very first.  I connected
> the frequency probe to the PLL reference oxcillator test point but instead
> of getting a 12090 reading, I got a fluctuating reading around 684.
> Themanual says this could be a problem with the probe or the PLL reference
> oscillator.
> 
> I think the probe is working okay, as it checks out on the other test points
> (but frequencies are off somewhat).  I've checked the solder connections in
> the reference oscillator area -- all okay.  Anybody have any suggestions?
> 
> Bob Greenwalt
> KG6QOL

-- 
Thomas M. Beaudry
k8la / ys1ztm
k8la at arrl dot net
K2 # 3422