[Elecraft] K2 akignment and test, part II

[Thomas M. Beaudry]

Duh...

I should have mentioned that I was talking about the connector at the
end of the probe.

> I just found my problem so you may want to check if you did the same...
> 
> I reversed the pins when I put them in the connector!!!!  Shows exactly
> what it's supposed to show now.
> 
> 73,
> 
>> I'm working on the RF board for my K2 #3452 and ran into a problem on the
>> alignment and test part II.
>>
>> Just started the test and ran into a problem on the very first.  I 
>> connected
>> the frequency probe to the PLL reference oxcillator test point but 
>> instead
>> of getting a 12090 reading, I got a fluctuating reading around 684.
>> Themanual says this could be a problem with the probe or the PLL 
>> reference
>> oscillator.
>>
>> I think the probe is working okay, as it checks out on the other test 
>> points
>> (but frequencies are off somewhat).  I've checked the solder 
>> connections in
>> the reference oscillator area -- all okay.  Anybody have any suggestions?
>>
>> Bob Greenwalt
>> KG6QOL
> 
> 


-- 
Thomas M. Beaudry
k8la / ys1ztm
k8la at arrl dot net
K2 # 3422