[Elecraft] Disaster!

[Edward Kenworthy]

Thanks Don, I do appear to have continuity still where I need it - phew!

On 6/7/03 3:45 am, "Don Wilhelm" <w3fpr@peoplepc.com> wrote:

> Edward,
> 
> A new control board would likely be a bit of overkill unless you have
> mounted only a few components.  Just follow the schematic diagram and run
> continuity checks from the connector pins to every other point that they are
> shown to connect with in the schematic.  Should you find any that are open
> (when they should be connected) it is a simple matter to connect between
> those points with a bit of No. 26 or 30 wire - it should work just as well
> as a brand new board when you are finished.
> 
> 73,
> Don W3FPR
> 
> ----- Original Message -----
> 
> 
>> I cut the connector up and removed all the pins but in the process I've
>> overheated two of the pads, whose corners have lifted a bit. One still has
>> continuity with the PCB, the other doesn't look like it was ever
> connected.
>> Am I still OK - or should I order a replacement control panel ?
>> 
> 
> 
>