[Elecraft] No TX on ssb

[Tom Buchanan]

Ron,

Yes the jumpers are in place and also the 5.6k resistor.

Tom

----- Original Message ----- 
From: "Ron D'Eau Claire" <rondec@easystreet.com>
To: "'Tom Buchanan'" <tlbuch@scrtc.com>; <elecraft@mailman.qth.net>
Sent: Tuesday, January 21, 2003 11:45 PM
Subject: RE: [Elecraft] No TX on ssb


> Do you have the microphone header jumpers in place? 
> 
> Ron AC7AC
> K2 #1289
> ======================
> I wonder what I am missing here?  I just put the KS2B module in and
> connected the MH2 mic.  Solder points look good and I followed the
> troubleshooting steps in the ssb adapter manual.  Checking the DC
> voltages on the ssb module with the DMM on both RX & TX the voltages are
> within the proper ranges.  No power out on ssb only.  Troubleshooting
> tips at the Elecraft website - "no TX power out?  Make sure C167 (RF) is
> installed." However in the manual for the ssb adapter C167 is removed.
> 
> Any ideas on what the problem might be?
> 
> Thanks,
> 
> Tom KG4KGY
> #2688
> 
>