[Elecraft] This mixer may interest some

[John]

How does the 602 or 802 handle the speaker level input?  I have also been
thinking about using one speaker that is driven by all of my rigs but I
would rather
not have to modify the rigs that don't have a line level output so I would
prefer to
drive the mixer with the speaker output from each rig.

John   K7SVV

----- Original Message -----
From: "George, W5YR" <w5yr@att.net>
To: <tlogan7@cox.net>; "Elecraft Reflector" <elecraft@mailman.qth.net>
Sent: Sunday, February 23, 2003 10:35 PM
Subject: RE: [Elecraft] This mixer may interest some


> Not familiar with that speaker, Tim, but if it is a powered speaker then,
> yes, that and the 602A are all you need. If not, then an amp of some sort
is
> required to get from the line-level output of the mixer to the speaker
with
> adequate driving power.
>
> If the operator is seeking a lot of bass response to listen to the hi-fi
AM
> and SSB stations, then it is desirable to use a fairly large speaker and
an
> amp that has adequate low-frequency power output for the room size, etc..
> Small speakers, properly enclosed, etc. are good down to 90 or 100 Hz
> perhaps but then the output starts falling fairly rapidly with frequency
and
> distortion rises if attempts are made to "equalize" the speaker by driving
> it harder at the lower frequencies. Communications-quality audio requires
> response only from about 300 to 3000 Hz so small speakers are adequate.
>
> 73/72, George
> Amateur Radio W5YR -  the Yellow Rose of Texas
> Fairview, TX 30 mi NE of Dallas in Collin county EM13QE
> "In the 57th year and it just keeps getting better!"
>
>
>
> -----Original Message-----
> From: tlogan7@cox.net [mailto:tlogan7@cox.net]
> Sent: Sunday, February 23, 2003 8:17 PM
> To: w5yr@att.net; Elecraft Reflector
> Subject: Re: [Elecraft] This mixer may interest some
>
>
> Hmmm -
> A bit confusing George - the fellow who described this to me mentioned the
> Soundsweet speaker and the 602 as if that was all he used. Had to have an
> amp in there somewhere huh?
> 73/Tim
>
> _______________________________________________
> Elecraft mailing list: Elecraft@mailman.qth.net
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com