[Elecraft] Next phase checkup

[Greg Fischer]

OK...

began resistance checks for FP.

U1 pins are a little low, but may be ok.
Pins 1 and 2 about 22k, manual says 25-35k

Then all OK till I get to J1.

No readings at all on pins 1-7
Pin 8 looked like it would be ok.  Started at 0, but then went to .2 ohms,
fluctuated between 0 and .3
pins 9-12 are fine
pin 13 shows no reading
pin 14 fine
pin 15 no reading
pins 16 and 17 are a little low, 22k
Pins 18-20 are OK.

no solder bridges or cold joints that I can find.  Any ideas.

Thanks as always.
Greg