[Elecraft] KAT100 LED assembly

[Vic Rosenthal]

Wayne Burdick wrote:
> 
> It's probably easier to stop at the epoxy coating on the leads and not force them down.
> Just equalize the height of all of the LEDs if some of them have such a coating.

It's not an epoxy coating...the leads have a little flat place on them, as if
they were squashed with pliers.  It appears to be intended to stop insertion at
this point.  The bottom of the LED is exactly 1/8" above the board when they are
pushed in as far as they go.  

Vic K2VCO