[Elecraft] K2 BFO Test Showing "0000.0"

[Kirby Davis]

Good Morning!

Since I won't be able to work again on my K2 for several days I thought I=

would go ahead and see if I might be able to get some help in the meantim=
e so
I can be "fully armed" when I get back to the project...

Last night I was going through the tests for the second phase of the RF b=
oard
assembly. All of the tests were going smoothly until the BFO test. When
conducting that test I received the "0000.0" display. I looked at the not=
e
following that step and also scanned through the Troubleshooting section =
but
it was getting late and I didn't have time to really digest it.

Has anyone else experienced this in building your K2? Could you possibly =
give
me some ideas as to where to begin looking for problems? As I mentioned,
everything else up to this point checked out fine. Also, I took off the b=
ottom
cover and it made no difference (I read one article on the reflector wher=
e
this action isolated a problem due to L33(?) being to close to the cover)=
=2E

Any assistance would be greatly appreciated!!

Thanks,

=2E.. Kirby (KB4UTZ)