[Elecraft] Stuck Again -- Sorta!

Wed Dec 4 21:06:01 2002

Ok, now I'm really confused! My Front Panel board only has 3 transistors on
it, your say it has 4??? Q1 & Q2 are below U1. Then Q3 is to the left and
below Q1 & Q2. In fact on my board Q3 is right about RP3? I'm really
confused now, where is RP1 suppose to be?

Jerry - NR5A
----- Original Message -----
From: "Dan Barker" <[email protected]>
To: "Elecraft" <[email protected]>
Sent: Wednesday, December 04, 2002 6:50 PM
Subject: FW: [Elecraft] Stuck Again -- Sorta!

> Use the PDF Version of the manual. Do a Locate (Find) on RP1. You'll see
all
> the references to RP1 in the book, including the instructions (you found
> that), the schematic (interesting, but doesn't help here) and the parts
> placement diagram (Oh yeah!). You'll see RP1 goes above the PIC chip and
> below 4 transistors (Q1-4).
>
> Dan / WG4S / K2 #2456
>
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Crashin J
> Sent: Wednesday, December 04, 2002 8:21 PM
> To: elecraft
> Subject: [Elecraft] Stuck Again -- Sorta!
>
>
> Ok, on the Control Panel board the manual says to put in RP1 which is a
sip
> resistor. Looking at the board I can't find a RP1! I do see a RP3 which is
> right above R3 & R4. Did I somehow overlook something? Where does RP1 go?
>
> Jerry - NR5A
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>
> _______________________________________________
> Elecraft mailing list: [email protected]
> You must be a list member to post to the list.
> Postings must be plain text (no HTML or attachments).
> See: http://mailman.qth.net/mailman/listinfo/elecraft
> Elecraft Web Page: http://www.elecraft.com
>