FW: [Elecraft] Stuck Again -- Sorta!

Wed Dec 4 20:53:01 2002

Use the PDF Version of the manual. Do a Locate (Find) on RP1. You'll see all
the references to RP1 in the book, including the instructions (you found
that), the schematic (interesting, but doesn't help here) and the parts
placement diagram (Oh yeah!). You'll see RP1 goes above the PIC chip and
below 4 transistors (Q1-4).

Dan / WG4S / K2 #2456

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Crashin J
Sent: Wednesday, December 04, 2002 8:21 PM
To: elecraft
Subject: [Elecraft] Stuck Again -- Sorta!

Ok, on the Control Panel board the manual says to put in RP1 which is a sip
resistor. Looking at the board I can't find a RP1! I do see a RP3 which is
right above R3 & R4. Did I somehow overlook something? Where does RP1 go?

Jerry - NR5A

_______________________________________________
Elecraft mailing list: [email protected]
You must be a list member to post to the list.
Postings must be plain text (no HTML or attachments).
See: http://mailman.qth.net/mailman/listinfo/elecraft
Elecraft Web Page: http://www.elecraft.com