[Elecraft] Jumper wires

Fri Aug 9 20:01:01 2002

I wonder if the folks at Elecraft realize the great therapy they are give us lonely, school crazed hams?  I wish to say thanks to them and hope for many more contemplative 
hours bending leads and soldering parts.  
   73 all and may your rigs work well for many, many years to come,
       Kevin.   KD5ONS


8/9/2002 5:36:41 PM, Jessie Oberreuter <[email protected]> wrote:


>     Just dealt with this a few nights ago :). R18 and R19 are "jumper
>wire" resistors.  The jumpers literally go where the resistors would.
>     I was completely planning on installing the KAF2 and was trying to be
>sure to not solder jumpers into places where pin headers were about to go
>when, blast!, I soldered the R18 and R19 jumper wires.  I promptly removed
>them and ordered the KAF2 (I'm using this kit to stave off loneliness from
>temporary lack of house mates, so I'm not moving too quickly :).  The KAF2
>arrived today, so I'll be soldering in the headers and then just plugging
>in jumpers :).