[Dx4win] Icom IC-7800 rig file

[Peter Bacon]

Guy, 
Thanks for looking.  I suspect that similar firmware upgrades will be made
available for other Icom rigs in the coming weeks, so there will be a lot of
interest in having Paul look at what will need implementing in DX4win to
support reading split frequencies across a wide range of Icom transceivers.
Peter G3ZSS

-----Original Message-----
From: ON4AOI [mailto:on4aoi at skynet.be] 
Sent: 26 December 2010 4:01 PM
To: peter at g3zss.com
Cc: dx4win at mailman.qth.net
Subject: RE: [Dx4win] Icom IC-7800 rig file

Well Peter,
It looks not that simple.
I compared the cat commands from the original release and what is changed in
the new release There are no new CI-V commands added Cmd 0F 00/01 is changed
from split off/on to read split setting 00/01 = off/on.

Cmd 1C is completely changed to what DX4WIN probably can to read the split
freq but the previous value-check for cmd 1C was never used in DX4WIN.
They were used to check if you were in RX/TX or to read the antenna tuner.
Think we have to wait after a solution from Paul 

Guy ON4AOI 
 

> -----Oorspronkelijk bericht-----
> Van: dx4win-bounces at mailman.qth.net [mailto:dx4win- 
> bounces at mailman.qth.net] Namens Peter Bacon
> Verzonden: zondag 26 december 2010 13:48
> Aan: dx4win at mailman.qth.net
> Onderwerp: [Dx4win] Icom IC-7800 rig file
> 
> I see that Icom has updated the firmware for the IC-7800 to ver 2.30.
> The new firmware include the long awaited ability to read split 
> frequencies.
> Has anyone figured out how to implement this in the DX4Win rig file/
> 73 Peter G3ZSS
> 
>