[Dx4win] CQ DX Field Submittal

[Jim Reisert AD1C]

Hi Bud,

If you want to pick specific QSLs, expand the QSO window using the F5
key until you see the award flags at the bottom.  You must "unsubmit"
the QSO you do not want to submit and "submit" the QSO you do want to
submit.  Change the award flags(s) to "--" and "S", respectively (make
sure to pay attention to mixed/band/mode award flags, change all the
are necessary).

When you are done, re-run the submission report.

This is just like every other award.

73 - JIm AD1C

On Fri, Oct 30, 2009 at 1:31 PM, Bud Governale, W3LL <w3ll at arrl.net> wrote:
> I'm getting ready to do a CQ DX Field Submission using V8.02
> Since there are separate awards for Mixed, Phone, Digital and certain selected bands, I put a check mark in Mixed, Band
> and Mode in the CQ Field Award choices.
>
> The Submission printouts for Mixed, Phone, Digital, 10M, 40M and 80M are all ok with one entry for each grid.
>
> However, I now want to choose specific QSL's to make the submission easier.
> If countries located within a single grid field are selected (identified in the application literature) and they are
> confirmed by a national organization (such as LOTW) then a submitted QSL is not required.
>
> Here's an example of my problem:
>
> Grid AG is only confirmed by two QSO's with ZL8R. One for 40M SSB and one for 15M RTTY.
>
> In the ZL8R 40M SSB QSO window, in the CQFld column, I put an S (submitted) in the Mode column (for SSB) and one S in
> the Band column (for 40M).
>
> In the ZL8R 15M RTTY QSO window, in the CQFld column, I put an S in the Mixed column ( RTTY now adds a Mixed mode to the
> previous SSB QSO) and one in the Mode column (for RTTY).
>
> Problem: Now when I print out the mixed submission listing (selecting award CQ DX Field, Checking only Mixed award,
> Selecting All Bands and All Modes) the printout has two entries for Grid AG. One for SSB and one for RTTY QSO's. Only
> one entry should be listed for each of the Grids for the mixed mode submission. In this case only the RTTY QSO should
> have been listed since it was the only one selected (S) for Mixed Mode.
>
> The above is just one example. I've done this for other grids that have the similar QSO combinations. Now my Mixed
> submission printout has many duplicate grid confirmations in it.
>
> How am I supposed to accomplish this?



-- 
Jim Reisert AD1C, <jjreisert at alum.mit.edu>, http://www.ad1c.us