[CW] Vibroplex Original Damper Wheel

[Joseph L Pontek Sr via CW]

I am trying to remember, but it seems there were shoulder screws used 
for the damper wheels, but I don't remember the vintage. It was not 
permanent
use for them.  I only saw a couple.  But, the screw should be screwed in 
until the damper is still loose. Holding the screw, put the nut on the 
back, snugly,
but not so tight as to pull the screw through and strip threads.

On 12/13/2014 10:06 PM, stan levandowski via CW wrote:
> I'm a bit confused here -- If I tighten down on the screw/bolt, the 
> damper wheel won't have any play.  If I don't tighten it, eventually 
> it can loosen. This doesn't seem like a very good design and I'm 
> afraid I'm missing something.  Perhaps the Original model isn't 
> supposed to have a "loose" damper wheel??

-- 
Regards, Joe, Ronnie (Rowena), Marty & Sidney Pontek
P.O. Box 280, Dangriga, Stann Creek District
(Hopkins Village) Belize
011-501-666-3564 Belize (cellular)
or
5204 Texas Highway 49 W
Omaha, TX 75571-6474
U.S.A.
903-434-9111 (My NEW cellular when in Texas)
903-884-5990 (Skype telephone number, Belize & TX)
Also, K8JP, member FOC-1743, CWops-876, QCWA-LM21894, OOTC-4607, A1OP, SKCC-3171T, NAQCC-5798, Flying Pig-2819, FISTS-7625CC951, A1C-2299, SOC 1075, 10-10 22977, PG1915841, CW Rag chewers #21,
Skype: v31joepalooka
Facebook: Joe Pontek
I am looking for Vibroplex Model X, Double lever and prefer basket cases to restore.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/cw/attachments/20141213/72f6fdc8/attachment.html>