[Boatanchors] Wafer switch lubrication preferences

[Carl]

I usually start with a tiny shot of PB Blaster on the detent ball to break 
loose the corrosion. Then rinse off with a couple of drops of lacquer 
thinner on a toothpick. Followed with a few drops of Hoppes #9 Gun Oil.

Carl
KM1H


----- Original Message ----- 
From: "Curt" <rhulett1 at comcast.net>
To: <Boatanchors at mailman.qth.net>
Sent: Wednesday, September 08, 2010 2:20 PM
Subject: [Boatanchors] Wafer switch lubrication preferences


> So far, I have avoided using de-oxit on any of my rigs, maintly because 
> none exhibit contact problems.  Also, have read horror stories of damage 
> done using de-oxit, so will confine use to contacts that aren't working 
> correctly.
>
> My recently acquired Eico 723's band selector switch doesn't move as 
> easily as it should, but contact is fine.
>
> What is the preferred lubricant to ease mechanical movement of these 
> switches?  I was considering white lithium grease, but thought would ask 
> first.
>
> Thanks, 73 Curt KB5JO
> ______________________________________________________________
> Boatanchors mailing list
> Home: http://mailman.qth.net/mailman/listinfo/boatanchors
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Boatanchors at mailman.qth.net
>
> List Administrator: Duane Fischer, W8DBF
> ** For Assistance: dfischer at usol.com **
>
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html