[Boatanchors] Re: GB> Dial Re-Stringing Madness!

[J Forster]

The HS tubing might work, but will likely the cord will indent into it after a
while...  Like lacing cord into Teflon  covered wire. Ditto the plastic tool
handle grip plastic. IMO, neither would be a long term solution. Likely the
drive rod was pretty highly polished as the dial cord started to slip.

FWIW,
-John

===========

Tom NØJMY - AAR7FV wrote:

> Realize, of course, that this is one of my two bong-hit ideas, but I
> wonder what a little thin-walled heat-shrink would do for you if you
> shrunk it over that part of the shaft?
>
> Or liquid plastic?  Or anything that could be brushed on in a thin coat
> that dries hard, but not "rock" hard.  Epoxy or whatever.
>
> 73,
> Tom