[ARC5] Removing set screws

[Michael Hanz]

Heh, heh...what heat setting do you use for thermoplastic knobs?:-)

- Mike  KC4TOS

On 11/18/2019 11:58 AM, Mike Feher wrote:
>
> Hi Dave –
>
> I have found that heat always work. This is even if Loctite was used. 
>  Once the appropriate wrench is found and doe not do the job by 
> itself, apply heat. When I run into a tough one, I plece the wrench 
> into the screw and secure the handle with long nose pliers. After that 
> I apply heat from a small torch for a few seconds and out comes the 
> screw. 73 – Mike
>
> Mike B. Feher, N4FS
>
> 89 Arnold Blvd.
>
> Howell NJ 07731
>
> 848-245-9115
>
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20191118/b1da9d2a/attachment.html>