[ARC5] Removing set screws

[Mike Feher]

Hi Dave – 

I have found that heat always work. This is even if Loctite was used.  Once the appropriate wrench is found and doe not do the job by itself, apply heat. When I run into a tough one, I plece the wrench into the screw and secure the handle with long nose pliers. After that I apply heat from a small torch for a few seconds and out comes the screw. 73 – Mike 

 

Mike B. Feher, N4FS

89 Arnold Blvd.

Howell NJ 07731

848-245-9115

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/arc5/attachments/20191118/b1c5384d/attachment.html>