[ARC5] BC-696-A Inductor Scale_capacitor rebuild

[Tom Elmore]

I just used a dremel tool cut off wheel to open one of the bathtub style
capacitors in order to rebuild it. I always though those were aluminum but I
recall reading somewhere that they are actually brass?  It looks like I can
solder the top part I cut off back on.

 

-Tom

 

From: Jay Coward [mailto:jcoward5452 at aol.com] 
Sent: Wednesday, November 27, 2013 4:06 PM
To: tom at telmore.com; ARC5 at mailman.qth.net
Subject: Re: [ARC5] BC-696-A Inductor Scale_capacitor rebuild

 

Yes, it's an arbitrary scale for logging purposes. ARC-5 and SCR/ATA are
different from each other but probably the same for each tx in their
respective series. So find a "parter" with a good window scale. You'll get
your bearings too most likely or a replacement part all together. But the
knowledge that you can rebuild one of these capacitors is good stuff to have
"under your belt".

Jay

-----Original Message-----
From: Tom Elmore <tom at telmore.com>
To: ARC5 <ARC5 at mailman.qth.net>
Sent: Wed, Nov 27, 2013 4:34 pm
Subject: [ARC5] BC-696-A Inductor Scale

Does anyone know if there is a scale in the roller inductor window of the
BC-696-A?  I just replaced the window and it seems like there should be
something in there to indentify the position of the roller inductor.  
 
 
 
 
 
 
 
 
 
 
 
Thank You 
 
 
 
Tom Elmore KA1NVZ
 
Anchorage, Alaska 
 
 
 
______________________________________________________________
ARC5 mailing list
Home: http://mailman.qth.net/mailman/listinfo/arc5
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:ARC5 at mailman.qth.net <mailto:ARC5 at mailman.qth.net?> 
 
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html