[1000mp] roofing filter and menu 9.1

[Jim W7RY]

No.
I was not talking about the IF mod. This thread is about the roofing 
filter. As stated before. I lowered my 9-1 setting 13 to 10.

My understanding is that the part of the IF modification was included in 
the roofing filter. Thus lowering 9-1 was required.

73
Jim W7RY


73At 05:44 AM 1/24/2005, you wrote:
>If you didn't have the previous INRAD mod installed, don't change the
>setting. If you make any changes make sure you make a note what the original
>number was.
>
>If you are concerned about the S meter you could try reducing the 9-1
>setting by one number. Or adjust for best signal to noise ratio as other
>posters have suggested. I believe most of those posts were talking about the
>if mod, not the roofing filter.
>
>73, Tom, W1TO
>
>----- Original Message -----
>From: "Kostas SV1DPI" <sv1dpi at raag.org>
>To: <1000mp at mailman.qth.net>
>Sent: Sunday, January 23, 2005 4:27 PM
>Subject: [1000mp] roofong filter and menu 9.1
>
>
> > I added the roofing filter in my MARK V.
> >     Does it need to decrease this value?
> >     I read in inrad manual that i need to increase if i had IF mode =
> >     installed (i didn't).
> >     I had the impression reading the emails here that i must decrease it.
> >     I noticed that s-meter is wrong now (without decreasing the 9.1 menu)
> >     Confused.....
> >     Kostas SV1DPI
> >
> >
> > _______________________________________________
> > 1000mp mailing list
> > 1000mp at mailman.qth.net
> > http://mailman.qth.net/mailman/listinfo/1000mp
>
>_______________________________________________
>1000mp mailing list
>1000mp at mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/1000mp